COLT MODELS Search for Colt Automatic Pistol or Revolver Model Model 1900 .38 ACP Model 1902 Sporting .38 ACP Model 1902 Military .38 ACP Model 1903 Pocket Hammer .38 ACP Model 1903 Pocket Hammerless .32 ACP Model 1905 Military .45 ACP Model 1907 .45 ACP U.S. Contract Model 1908 Pocket Hammerless .380 ACP Model 1908 Vest Pocket .25 ACP Junior .22 LR & .25 ACP Model 1909 .45 ACP Model 1910 .45 ACP Model 1911 U.S. Army .45 ACP Model 1911A1 U.S. Army .45 ACP Government Model .45 ACP (Commercial) Ace .22 LR National Match .45 ACP Service Model Ace .22 LR Super .38 ACP Super Match .38 ACP .45-.22 Conversion Unit .22-.45 Service Model Conversion Unit .22 Target, Woodsman, Match Target and related ------------------------------ Revolvers ----------------------------- Single Action Army & Bisley New Line Army Special .32-20,.38 & .41 Bankers Special .22 & .38 Camp Perry .22 Commando .38 Detective Special .38 New Army & New Navy New Pocket New Police New Service & New Service Target Official Police Pocket Positive Police Positive, Police Positive Target and Pequano Police Positive Special Target .22 Short & Long Rifle Shooting Master ------------------------------ Derringers ---------------------------- Thuer Third Model Derringer 41
Always make sure pistol is unloaded!
1. Open up a large paper clip.
2. Cock hammer and remove magazine
3. Turn pistol upside down and pull back slide approximately 1/2" holding it in that position.
4. Insert unbent end of paper clip through hole in the lower front frame until it touches the slide lock.
5. Leave paper clip in that position and release slide to move forward. There should now be play in slide movement. (paper clip should remain in this position until pistol is reassembled.)
6. With the left side of the pistol facing down, the slide lock should drop out. Now the slide can be withdrawn from the rear. No force is required to remove the slide lock. The slide lock will only exit the pistol from the left side.
7. Assemble in reverse order remembering to line up the small pin on the slide lock with the corresponding cut in the slide. Make sure lock is securely in place before removing paper clip.
NOTE: Further disassembly of the Model 1900 requires the removal of pins and is not recommended.
1. Remove magazine
2. Depress spring loaded concave plug 1/8". Depressing the plug releases tension on the slide lock
3. With the left side of the pistol facing down, depress plug completely while pushing on right side of slide lock. The slide lock should drop out. Cock hammer and withdraw slide from the rear. No force is required to remove the slide lock. The slide lock will only exit the pistol from the left side.
4. Assemble in reverse order remembering to line up the small pin on the slide lock with the corresponding cut in the slide. Slide lock must be inserted from the left side while concave plug is fully depressed.
Gun of the Month
January 2022
Contact Us
The Rampant Horse and Colt logos are registered trademarks of Colt's Manufacturing Company, Inc. Hartford, CT
Copyright © 1996 - 2025 by Coltautos.com. All rights reserved. Please read our online Privacy Statement The Coltautos.com logos and all proprietary artwork and photos are the property of Coltautos.com and may not be reproduced or distributed without expressed written permission.
